Responsive image
博碩士論文 etd-0802101-135544 詳細資訊
Title page for etd-0802101-135544
論文名稱
Title
泛用型數位變頻器
General Digital Inverter
系所名稱
Department
畢業學年期
Year, semester
語文別
Language
學位類別
Degree
頁數
Number of pages
49
研究生
Author
指導教授
Advisor
召集委員
Convenor
口試委員
Advisory Committee
口試日期
Date of Exam
2001-07-20
繳交日期
Date of Submission
2001-08-02
關鍵字
Keywords
數位訊號處理器、變壓變頻控制、感應馬達驅動器
DSP, Induction Motor Drive, Variable Voltage Variable Frequency Control
統計
Statistics
本論文已被瀏覽 5700 次,被下載 9146
The thesis/dissertation has been browsed 5700 times, has been downloaded 9146 times.
中文摘要
摘要
本論文設計並製作一以數位訊號處理器(DSP)為基礎之變頻驅動器。以V/F控制方法做有效的交流馬達控制。並將電路以PCB轉換成印刷電路板將其模組化,本變頻器分為數位板,及類比電源板,並將兩部分加以連接,並以三相感應機作為負載,將一個變頻器的實體以印刷電路板的概念做出。因為數位板是用數位訊號處理器做成,適合大量的數學運算,易以軟體撰寫控制理論,故本次論文也以非對稱脈寬調變模式來計算三相閘極的開關訊號。
Abstract
Abstract:
This paper designs and implements a DSP-microprocessor based motor driver. We control the induction motor with V/F scheme. And we module all circuits with PCB Layout.This Inverter is compose of digital board and analog-power board. We connect two parts, and we use a three phase induction motorto to be the load. Because the digital board is compose of DSP, it is to fit a lot of mathematics. It is easy to use the software to present the theory. So the paper compute the three phase gate signals with asymmetrical Pulse-Width-Modulation model.
目次 Table of Contents
目錄
第一章 緒論 1
1-1 前言 1
1-2 研究動機 1
1-3 本文架構 3

第二章 三相感應馬達數學模型 4
2-1 交流感應馬達轉動原理 4
2-2 交流感應馬達數學模型的建立與推導 5
2-3 d-q軸座標轉換 10

第三章 變頻器之控制原理 15
3-1 純量控制法則的原理 15
3-2 純量控制之穩態分析 17
3-3 V/F曲線之設計 20

第四章 變頻器之系統架構設計 22
4-1 數位控制單元 24
4-1-1 數位訊號處理器 24
4-1-2 數位訊號處理器Boost方法介紹 26
4-2 閘極驅動單元 27
4-2-1 電源供應電路 27
4-2-2 脈波寬度調變電路 28
4-2-3 換流器與閘驅動電路 29
4-2-4 電流感測電路 31
4-3 電路佈局 32
4-3-1 電路元件的放置 32
4-3-2 電路板接地線的佈局 34
4-3-3 電路板電源線的佈局 37

第五章 實驗結果 41

第六章 結論 48

參考文獻 49

參考文獻 References
1.李清吟,楊新全編譯,“電機機械”,全華圖書,1998。
2.陳正哲,“伺服電力電子”,文笙書局,民國84年2月。
3.陳秋麟,李哲銘,劉益華,“感應馬達之純量、直接轉矩及向量控制,”
電機月刊,1998年元月。
4.仲成儀器股份有限公司編輯部 編著“交流感應伺服馬達控制”
全華圖書,民國83年9月。
5. 劉昌煥,許溢适,“變頻器實用電路設計與驅動軟體,”文笙書局,
民國85年10月。
6.羅久琅,“具有強韌積分結構控制法則之交流感應馬達伺服驅動器,”
碩士論文,國立中山大學電機工程研究所,民國86年6月。
7楊堆詣,“以數位訊號處理器為基礎之高頻變頻器研製,”
碩士論文,國立中山大學電機工程研究所,民國87年6月。
8.鄭世賢,“非對稱脈寬調變模式之高性能變頻器,”
碩士論文,國立中山大學電機工程研究所,民國88年6月。
9.ADMC401 Applicaion Notes“Three-Phase PWM Generation Unit Of the
ADMC401,”Analog Devices,1999.
10.ADMC401 Applicaion Notes“Constant Volts/Hertz Operation For Variable Speed Control Of Induction Motors,”Analog Devices,1999.
11.ADMC401 Data Sheet, Analog Devices,1999.
12.ADMC401 Applicaion Notes“Generation of Three-Phase Sine-Wave PWM Patterns On the ADMC401,”Analog Devices,1999.
13.Bruce Carter“The PCB is a component of amp design,”Analog and Mixed-Singal Products,2000
14.Tom Hendrick “Reducing PCB design costs: From schematic capture to PCB layout,” Analog and Mixed-Singal Products,2000



電子全文 Fulltext
本電子全文僅授權使用者為學術研究之目的,進行個人非營利性質之檢索、閱讀、列印。請遵守中華民國著作權法之相關規定,切勿任意重製、散佈、改作、轉貼、播送,以免觸法。
論文使用權限 Thesis access permission:校內立即公開,校外一年後公開 off campus withheld
開放時間 Available:
校內 Campus: 已公開 available
校外 Off-campus: 已公開 available


紙本論文 Printed copies
紙本論文的公開資訊在102學年度以後相對較為完整。如果需要查詢101學年度以前的紙本論文公開資訊,請聯繫圖資處紙本論文服務櫃台。如有不便之處敬請見諒。
開放時間 available 已公開 available

QR Code